Peterson system314对烟草的影响

appine

前几天拿到一支Peterson 2008 Launch 500支限量版，其实就是Peterson System 314和Zippo对应加了钢印。单是烟斗国外网购加运费大概38英镑，不知道要不要加关税，没试过，大概会碰运气吧。下面谈谈使用的体会，用Scotland Wisky涂后开的斗，使用了六七次，刚加满，烟草主要是：Larsen:32 80 50,Dtm:Hamburger1982和Torben Dansk No.11，英式调配。对比这些烟草在Bari直斗的使用发现：
1。这些烟草在P中的层次不如在B中明显，特别是DTM的烟草，Torben 11 在直斗中有丰富的层次，在P中无法体现，P中就像白开水。原因可能是P嘴的通烟量有关，P嘴很小，每口的通烟量较少。
2。P的烟道开口较高，底部烟草无法燃尽，如果猛吸，一是不敢因为是新斗，另外烟灰容易入嘴。没有看过其它System 的烟道开口，不过我想系统烟斗的构造中烟道和钵的夹角都很小，其它的开口也不会低，就是相比直斗无法开在最底部。
3。P的钵壁较薄，但不烫手，说明用材不错。

Peterson 是知名大厂，用料是无可挑剔的，这个价位的用材我估计值得信赖。看来主要是P嘴的设计有其局限性，优点不言自明相信研究过的都明白。我觉得System的烟斗主要应该用在浓烈的烟草手上可以体现出他的优点。我是新手，刚入道一个月，还没有尝过原味，不知道马林和5110用在system 上会有何种变化，呵呵。请坛中TX点评我的心得，是否正确，求教ing(等烟斗吹干清理后上传图片）

[ 本帖最后由 appine 于 2009-3-3 20:53 编辑 ]

jt

I just saw this topic and would like to comment.

I repost what Mike Leverette said:

For the Peterson System pipes to work properly, the stem/tenon has to have an extension, the tip of which will pass by the draft hole from the bowl and into the sump. Upon the smoker drawing in smoke, this extension then directs the smoke down and around the sump to dispense a lot of the moisture before the smoke enters the extension and stem. On the System Standards and other less expensive systems, this extension with be made of vulcanite turned integrally with the stem. On the more expensive System pipes this extension will be made of metal which screws into the vulcanite stem. This extension on the earlier pipes will be of brass and the newer pipes will be of aluminum. Most smokers not knowing this function of the metal extension, assumes that it is a condenser/stinger and will remove it as they do with the metal condensers of Kaywoodie, etc. Should you have a System pipe with this metal extension, please do not remove it for it will make the System function properly and give you dryer smoke.

It is sad to say but I have two brand new Peterson Systems which came from the factory without the extension. So quality control is lacking to a certain degree.

Another feature of the Peterson System pipe that helps in removing moisture is the stem itself. It will have a relatively small draft hole entrance at the extension which will open out rapidly and then closes back down near the bit. Of course these varying diameters have smooth transitions. The idea behind this is; the smoke leaving the smaller diameter and entering the larger diameter will expand and slow down, thus dropping more moisture before entering your mouth.

The scan is of an illustration in Peterson

prokenny

這把批特森直斗  村中前輩萬寶路兄也有一把

呵呵 草民等等轉po這張插圖過去給萬兄的帖子

appine

Thanks Jcats for your reply which let me learn  more about system standard. Now  I have been good at smoking with the peterson system standerd, and  find that Robert Mcconnell The Original Scottish Flake in this pipe has an attractive taste. After several day I will write the tobacco's review about that perfect pair.

[ 本帖最后由 appine 于 2009-3-3 20:53 编辑 ]