蓝标
- 注册时间
- 2008-10-10
- 最后登录
- 2017-3-31
|
发表于 2012-1-20 19:42:06
|
显示全部楼层
"…..Soft spots in the bowl, which char faster and are noted as spider webbing, are often the cause of uneven reaming if done by hand. If using a knife, these softer areas could concave and cause a bigger problem in the future, so great care must be taken to ream the chamber evenly. With the lathe we are able to restore the chamber so the end result is a smooth surface that is clean to the touch." Posted by adam
http://www.smokingpipes.com/blog ... DE-552D7D87C04ECE0C
"A soft spot usually means a spot inside the bowl (that extends to the outside) where the briar is soft(er) instead of hard. That spot will get very hot very fast until a protective cake is built up. Sometimes a soft spot means the pipe was made with a piece of briar that is soft and sometimes it means the smoker burned a small soft spot in the briar by overpuffing.
If you buy this pipe, you'll have to be careful. Let the pipe go out the second it gets hot in that spot (you'll have to wrap your hand around the bowl as you smoke so you'll know when that happens). Relight when it cools and repeat until you get a protective cake."
Posted by dmkerr |
|
发表于 2012-1-20 18:50:10
发表于 2012-1-20 19:31:39
楼主